IC-7200 | ICOM

ICOM » IC-7200 — Price & Specifications

HF and 6 meter transceiver with rugged design for outdoor use. Tough construction against water intrusion. Front facing speaker. 100 Watt max output power on all bands. Ideated in Japan, year of introduction 2008.

Reference market : ham-radio

General :
Frequency coverage RX 0.0300 ~ 60.0000 MHz [1]
TX [2] 1.8000 ~ 1.9999 MHz
3.5000 ~ 3.9999 MHz
5.2550 ~ 5.4050 MHz [3]
7.0000 ~ 7.3000 MHz
10.1000 ~ 10.1500 MHz
14.0000 ~ 14.3500 MHz
18.0680 ~ 18.1680 MHz
21.0000 ~ 21.4500 MHz
24.8900 ~ 24.9900 MHz
28.0000 ~ 29.7000 MHz
50.0000 ~ 54.0000 MHz
Modulation mode CW / FSK (RTTY) / LSB / USB / AM
Tuning step 1 / 10 / 50 [4] / 100 Hz / 1 / 5 / 9 / 10 KHz
Receiver :
Sensitivity [5] SSB / CW < 0.16 uV (1.8~30 MHz, 10dB S/N)
< 0.13 uV (50~54 MHz, 10dB S/N)
AM < 13 uV (0.5~1.8 MHz, 10dB S/N)
< 2.0 uV (1.8~30 MHz, 10dB S/N)
< 1.0 uV (50~54 MHz, 10dB S/N)
Selectivity CW [6] > 0.50 KHz (-6dB)
< 0.90 KHz (-60dB)
RTTY [7] > 0.36 KHz (-6dB)
< 0.65 KHz (-60dB)
SSB [8] > 2.4 KHz (-6dB)
< 3.6 KHz (-60dB)
AM [9] > 6 KHz (-6dB)
< 15 KHz (-60dB)
RF preamplifier Yes
RF attenuator 20dB
Reciprocal mixing dynamic range (RMDR) [10] 92 dB (5 KHz spaced signals, 14 MHz, pre OFF)
103 dB (20 KHz spaced signals, 14 MHz, pre OFF)
Blocking [10] 102 dB (5 KHz spaced signal, 14 MHz, pre OFF)
138 dB (20 KHz spaced signal, 14 MHz, pre OFF)
Image and spurious rejection [11] > 70 dB
Twin PBT 50 Hz steps (SSB/CW/RTTY)
200 Hz steps (AM)
Notch attenuation (Manual) > 70 dB
Notch attenuation (Auto) [12] > 40 dB
CW features Semi break-in / full break-in
Pitch control 300~900 Hz in 10 Hz steps
Reverse mode L/USB
Noise blanker (NB) Level and width are adjustable in 100 steps
Noise reduction attenuation (NR) Adjustable in 16 steps
RIT variable range ± 9.999 KHz
AGC Off, fast, slow
Frequency stability ± 0.5 ppm max
Intermediate frequency 64.455 MHz
455.0 KHz
15.625 KHz
Squelch sensitivity SSB < 5.6 uV (threshold, preamp ON)
Transmitter :
Output power SSB / CW / RTTY 2 ~ 100 W (1.8~54 MHz bands)
AM 1 ~ 25 W (1.8~54 MHz bands)
Spurious emission < -50 dB (1.8~29.7 MHz bands)
< -63 dB (50 MHz band)
Carrier suppression (SSB) > 50 dB
Unwanted sideband suppression (SSB) > 50 dB
Microphone 600Ω
CW features 6~60 wpm Keyer
Features :
Memory 199 regular memories
2 for programmed scan limits
Display 1 Hz frequency resolution
15-segments signal meter bar
Antenna SO239 50Ω connector
Power supply 13.8 Volt DC ±15% external
Power consumption 2.0A RX, max volume
1.3A RX, squelched
22A TX, max power
Audio power 2W with an 8Ω load
Audio output Jack 6.35 mm headphone
Jack 3.5 mm external speaker
Connections Jack 8-pin (microphone)
Jack 3.5 mm (CI-V remote control)
Jack 6.35 mm (CW keyer)
RCA (ALC)
RCA (SEND)
Socket 13-pin (accessories)
Socket 4-pin (antenna tuner)
USB (PC, modulation input)
Mechanical and environmental data :
Operating temperature from -10°C to +60°C
Dimensions 241 (W) x 84 (H) x 281 (D) mm projections not included
Weight 5.5kg

[1] Guaranteed range 0.5-29.7 and 50-54 MHz
[2] Varies according to version
[3] USA version, only on 5.3305 / 5.3465 / 5.3665 / 5.3715 / 5.4035 MHz
[4] The frequency is changed in 50 Hz step when the [UP]/[DN] switches of the microphone are used
[5] Preamplifier ON, filter shape on SHARP
[6] 500 Hz bandwidth, filter shape on SHARP
[7] 350 Hz bandwidth
[8] 2400 Hz bandwidth, filter shape on SHARP
[9] 6000 Hz bandwidth
[10] This parameter, not in official data, was obtained with direct tests
[11] Except 1/2 IF through on 50MHz band
[12] Two beat tones

Description :

The IC-7200 is an HF/6 meter transceiver with rugged design. Combines some of the IC-7000's solutions with a compact case, ready for outdoor use thanks to a construction against water intrusion and a convenient front facing speaker. Features: RIT, noise blanker for pulse-type noise such as engine ignition and sparking, VOX, high frequency stability, LCD backlight high/low/off, CI-V interface, built-in preamplifier and attenuator, RF speech compressor, dial lock, auto TS function, 1Hz step tuning, band stacking register, built-in voice synthesizer, quick set mode, USB port for PC control.

Digital IF filter with Twin PBT:

The DSP allows you to flexibly select the filter width and shape from Soft and Sharp (on CW/SSB) and provides cutting edge characteristics. You can also tailor your IF filter with the Twin PBT by shifting the upper and lower edges, depending on the use of the concentric knobs you can either narrow the IF passband or shift the entire passband to eliminate interfering signals. Here the bandwidth available.

Mode Passband width
CW 50 ~ 3600 Hz
(up to 500 Hz with 50 Hz step, from 600 Hz with 100 Hz step)
RTTY 50 ~ 2700 Hz
(up to 500 Hz with 50 Hz step, from 600 Hz with 100 Hz step)
SSB 50 ~ 3600 Hz
(up to 500 Hz with 50 Hz step, from 600 Hz with 100 Hz step)
AM 200 ~ 8000 Hz
(with 200 Hz step)

Construction against water intrusion, and more:

Waterproof protection technologies that are used in ICOM's marine radios are applied in the IC7200 to the buttons and knobs on the front panel to provide a measure of protection against water intrusion. The rear bumper protects various connectors on the panel and lets you stand the radio on its rear end when the antenna is disconnected, such as while moving or packing the radio. The optional handles are convenient when moving the transceiver and can protect the face and radio knobs during transport.

IC-7200 price :

We have collected for your convenience the IC-7200 ICOM sales prices and their trend over time. Of course offers, accessories, warranty terms and conditions can lead to different figures.

Price Date Condition
EUR 490,-- 2018-oct Second Hand

Excellent condition, as new. Comes with microphone, manuals and box.

Review :

Your opinion on merits, defects, experiences, with this radio set is welcome. Write your review, after a technical evaluation by our staff if found suitable will be published on this page. We thank you for your precious contribution.

RadioMasterList.com

Copyright. All rights reserved.


Top